By comparison, this is port 2222 for older AB equipment such as the 5/05.Īlways remember that anyone with your IP address, and the right software has access to your processor now. If not, then just forward port 44818 to your ENBT module. Most routers have a DMZ (Demilitarized Zone) setting. In this case, my IP address of the ENBT is 192.168.1.17. I’m going to look at my ControlLogix ENBT module, and the IP address scrolls across the alphanumeric display. If these match, we are in good shape to continue! Set up routing to the ControlLogix Ethernet ModuleĪt this time, we are ready to set up the routing. Of course, for security reasons, I’ve manipulated the image below. I’ll go to the configuration page of the main router. Let’s say this website shows my address as 50.116.19.134.Īt this time, I’ll check the IP address that my router has on it’s WAN port. For this to work, I want them to be the same. That will tell me if my router has a public IP address, or if the ISP is shielding and re-distributing IP addresses through NAT. After that, I can check my main router to see if it has the same IP address. The easiest way to do this is to visit a web server that tells us what IP address it sees. Check your Internet IPīefore starting, let’s see if I have a public IP address. FactoryTalk View SE Trends and Data LogĪdditionally, this procedure will work on other processors, such as a SLC 5/05 or PLC-5 on Ethernet.Beginning a FactoryTalk View SE Project.Derivative Settings for ControlLogix PID Enhanced.Integral Settings for ControlLogix PID Enhanced.Proportional Settings for ControlLogix PID Enhanced (PIDE).Proportional, Integral, Derivative (PID).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |